Traditionally, support for IDE/ATA hard disks has been provided by the system BIOS and
operating system. This support was at first limited the simple programmed I/O (PIO) access modes. Over time, the IDE/ATA world has moved away
from PIO towards DMA modes. At first this was because DMA
modes allow hard disk transfers to occur without excessive CPU utilization--PIO
modes drag down the CPU while DMA modes allow transfers to occur while letting the CPU do
other things. With the introduction of Ultra DMA, DMA support became that much more
important.
DMA began to rise in popularity at around the time the first version of Windows 95 was
released. Unfortunately, Windows 95 "A" did not have native support for
first-party bus mastering DMA, so special drivers had to be added to support DMA. These
frequently caused compatibility and stability issues, and it took several years for DMA
support to "mature". Starting with the second OEM-only release of Windows 95
("OEM SR2", "Windows 95b") DMA support was provided by the operating
system. Windows 98 and Windows ME also provide built-in support for DMA operation, and DMA
works quite well today.
On modern systems, DMA support should be enabled by default. You can check for DMA
support by looking in the Device Manager. From the Control Panel, open "System",
then click the "Device Manager" tab. Open the icon for "Disk drives",
and then highlight the drive you are interested in. Click "Properties" and then
the "Settings" tab. Among the other settings you should find a "DMA"
check box, which should be checked. If it is not, try checking it to enable DMA support.
If you then reboot and the check box does not stay checked, this probably means your
system does not support Ultra DMA; try looking on this page to be
sure you meet all the requirements.
|
The "Settings" page for a DMA-capable hard
disk under Windows 95,
accessed through the Control Panel. Note the DMA checkbox. |
Note: Hard drives
connected to some Ultra DMA add-in controllers will not display a "DMA
checkbox". Since these cards are designed primarily to provide Ultra DMA
support, they don't bother showing it as an explicit option.
Next: Performance Factors and Tradeoffs in Configuring
for Multiple Devices
